Dedicated circuits
Dedicated Circuit Installation in Lake Forest Park
When one appliance takes out half the house, the appliance is rarely the thing at fault.
Heavy loads on their own supply
Houses built for a much smaller appliance list are now running several large ones at once, often off circuits that were never meant to carry them. They keep tripping, and resetting changes nothing. A dedicated circuit runs from the panel to one piece of equipment and nothing else. Around here it is just as often a feeder: a shed or studio part-way down a slope, fed years ago off a house circuit as a temporary measure that quietly became permanent.
What is included
The right size, not the biggest
Conductor and breaker matched to the nameplate, and to the run length.
A route planned for the lot
Crawl space, attic or underground, with the slope taken into account rather than ignored.
Panel capacity checked first
If the circuit pushes the service past what it carries, you hear it before we start.
Permit, inspection and labelling
Filed where required, inspected, and the breaker marked.
Why people call
The breaker goes on start-up
Motors and compressors draw far more starting than running.
Lights dim when something kicks in
Voltage drop — too much on one run, or a run too long for its size.
A new appliance has arrived
Ranges, wall ovens and air handlers want their own circuit.
There is a shed or studio down the slope
Fed off a house circuit, these are a steady source of trouble here.
How the work runs
Read the nameplate
The equipment states what it needs.
Check the panel
Spare capacity and a free slot, or the options if neither.
Plan and run
Route chosen for the lot, properly supported and protected.
Test and inspect
Under load, then signed off and labelled.
Questions about this work
How do I know I need one?
If one specific appliance causes the trip, almost certainly. Random trips point to a fault instead.
Can you run power to a shed down the slope?
Yes — a feeder, usually underground, with a disconnect at the far end. Quoted properly rather than run on a cord.
Will my panel take another circuit?
Often yes, and where it will not there are usually answers short of an upgrade.
Stop resetting the same breaker
Tell us what trips it and we will tell you whether a dedicated circuit is the answer.